![]() The default value of 25% is a good value. Higher (%) values result in a lower sensitivity of the joystick axes with small deflections (fine-tuning), while at higher deflections, So for example half deflection of the pitch axis causes half deflection of theĬontrol surfaces on the aircraft. If the controls are at 0%, then the control signalsĪre sent to the linear displacement of the corresponding axis of the joystick into X-Plane. The right 3 sliders controls the effect of the 3 axis pitch, roll and yaw of the joystick when it is moved accordingly. The left 3 sliders regulate the 3 axis pitch, roll and yaw and forces X-Plane 10 to support the pilot. The other possible settings in the upper area of the window are the following: Than you can complete the calibration of the nullzone by clicking on "Center yoke and pedals and hit this Button". Then you can, by adjusting the slider "nullzone" on slightly higher % values, prevent these signals. Some joysticks also deliver signals when they are not moving. It must then be recalibrated.Īdditional settings for the control axes must be made under this tab. Thus, the axes are defined and calibrated.Ĭlicking on the button "calibrate joystick hardware" resets the settings. Now click onto the "Use THIS position as CENTER" button. Now move all defined (green) axes sequentially throughout their range and then let it go in the middle position (throttle to zero, etc). Otherwise, these "red" Axis send signals to X-Plane and cause dysregulation of the aircraft. Throttle, propeller, mixture, brakes (maybe left and right), etc.Īll remaining red axes must be occupied with None (no function). In the same way you can/must calibrate more axes: Into the menu next to the display, which has moved, select Yaw. Turn the joystick to the left and right (if possible) or the rudder pedals (if any) pass to the left and right. Into the menu next to the display, which has moved, select Roll (rolling). Move the joystick completely left and right. Into the menu next to the display, which has moved, select pitch (pitch). Move the joystick now completely back and forth. It opens a window with several tabs: Axis, Nullzone, etc. Move the mouse to the top of the screen and click on "Settings" - select "Joystick & Equipment" Here is the procedure to calibrate a connected USB joystick with X-Plane 10: Thus the aircraft and helicopters etc can be controlled properly, the calibration has to be done within the X-Plane 10 simulator.įor this you must necessarily take some time. This OS-calibration is only valid for the operating system. In no case it is sufficient to perform the calibration of the hardware only with the included software. The same goes for the throttle, rudder pedals, brakes or the yoke. In X-Plane 10, you are able to calibrate the joystick very accurate and versatile. Calibrating the joystick axes in X-Plane 10
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |